Whirlpool Washer Not Spinning And Draining Properly At Tiffany Perry Blog Common reasons for a whirlpool front load washer not draining, spinning, or leaving wet loads at the end of the cycle: delicate or handwash cycle selected. extra low, low or no spin option selected. washing one bulky item. excessive suds. drain hose kinked or drain clogged. drain hose more than 96” above the floor. The drain pump may be clogged or defective. if your machine has a belt, check it. check the door lock or lid switch (most common issue) the clutch (not a common issue) the washer timer or control board failed (not common issue) unbalanced load. drain hose clogged. shift actuator failed. drain filter clogged.
Whirlpool Washer Not Spinning And Draining Properly At Tiffany Perry Blog If so, the drain pump is failing. if it won't spin, there is likely a problem with the water level sensing system. you will want to check to see if the drain hose is clogged. if it is, clean it out. check to see if the filter is clogged, as the machine may not be able to drain properly with a clogged filter. If your washer isn’t draining, check the drain pump for any obstructions. remove any blockages you find and test the washer to ensure it drains properly. if the water can’t drain, the washer won’t spin. 5. replace the motor coupling. if the motor coupling is broken, you’ll need to replace it. 1. faulty lid switch. the lid switch turns off the washer when its lid is not closed properly. you have to check the lid switch first if your washer is not spinning. if the lid switch turns of when it shouldn’t, it stops the washer’s spinning movement. you can check the lid switch by following the given steps. The drive belt in a whirlpool washer connects the motor to the drum, allowing it to spin. if the belt is worn, stretched, or broken, the drum won't spin properly. signs of a failing belt include a squealing noise during operation or visible wear on the belt itself. unplug the washer from the power source, turn off the water supply to the washer.
Whirlpool Washer Not Spinning And Draining Properly At Tiffany Perry Blog 1. faulty lid switch. the lid switch turns off the washer when its lid is not closed properly. you have to check the lid switch first if your washer is not spinning. if the lid switch turns of when it shouldn’t, it stops the washer’s spinning movement. you can check the lid switch by following the given steps. The drive belt in a whirlpool washer connects the motor to the drum, allowing it to spin. if the belt is worn, stretched, or broken, the drum won't spin properly. signs of a failing belt include a squealing noise during operation or visible wear on the belt itself. unplug the washer from the power source, turn off the water supply to the washer. Conclusion. when your whirlpool washing machine is not draining, try the following solutions to fix it: inspect and clean the drain hose. clean the drain pump filter. check the door latch switch. check and clean the coin trap. inspect the drain pump, and replace if faulty. Conclusion. the most common reason why your whirlpool washer isn’t draining completely is a blocked or clogged drain hose or drain pump. it could also be due to excessive suds, a slow spin cycle, or low outlet voltage. good luck!.
Comments are closed.