Replacing An Old Gate Valve Plumber Plumbing

Replacing An Old Gate Valve Plumber Plumbing Youtube Shut off the water, which will lead to the valve being replaced. this may involve turning off the main water supply to your home. use an emery cloth to clean the pipe on either side of the old valve. this creates a good seal for the new valve. cut through the pipe on each side of the old valve with a mini hacksaw. Close the new valve. open the water main shutoff valve and let the water run until all the air is out of the pipes. then shut off the upper and lower faucets. check the new valves for leaks. turn the water heater gas valve back to ‘on,’ or flip on the circuit breakers to the electric water heater. step 6.

Broken Gate Valve Repair Or Fixing Valves That Won T Close Plumbing and heating contractor richard trethewey shows how to replace an old, corroded water supply valve, without soldering. (see below for a shopping list. Anthony pacilla. for the service technician, valves are an essential feature of a plumbing distribution system. while servicing a piece of equipment or water control, you will run into two types of valves (on residential service) — the wheel handle style gate valve and the ball valve. the ball please login or register to view plumber articles. Buy a threaded replacement ball valve; it’s a far better choice than the older gate style valve. screw on the new ball valve, install the old nipple and the new leather washer (use teflon tape or pipe dope on the threads). tighten the coupling nut, turn on the water and check for leaks. step 4. I have this old setup. what i'm wanting to do is replace the old gate valves with new ball valves. i realized though if i cut all the old gate valves and replace them there probably isn't going to be any pipe slack to put back together. in a situation like this, what is the best way to go about it? p.s.

Replacing A Gate Valve With A Ball Valve Plumbing Plumber Howto Diy Buy a threaded replacement ball valve; it’s a far better choice than the older gate style valve. screw on the new ball valve, install the old nipple and the new leather washer (use teflon tape or pipe dope on the threads). tighten the coupling nut, turn on the water and check for leaks. step 4. I have this old setup. what i'm wanting to do is replace the old gate valves with new ball valves. i realized though if i cut all the old gate valves and replace them there probably isn't going to be any pipe slack to put back together. in a situation like this, what is the best way to go about it? p.s. 4. drain and verify the water is off. if the valve you shut off is located in a basement or first floor of a two story house, the water above you must drain out. most systems are not airtight enough to hold back the leftover water. start draining the system, and wait a few minutes for everything to get out. Open the valve completely to keep the internal washer from melting. next, heat the fitting using the propane torch. when the flux begins to bubble, apply the solder at the joint. use about 1 2 inch of solder for 1 2 inch of pipe diameter. wipe the joint clean with a dry cloth before the solder dries.