Hyundai Elantra Md Ud Coolant Repair Procedures Cooling System Repeat step 11 to 16 until the coolant level doesn't fall any more, bleed air out of the cooling system. it takes time to bleed out all the air in the cooling system. refill coolant when coolant gets cool completely, then recheck the coolant level in the reservoir tank for 2~3 days after replacing coolant. The video below (for kona, but the same 2.0 nu engine elantra has) mentions you would need hyundai's diagnostic tool to bleed the system since the thermostat is electronic. would filling as much coolant as possible while the engine is cold, and continuing to do so after starting the engine with the heater on (waiting for the thermostat to open.
Hyundai Elantra Removal And Installation Radiator Repair Procedures Turbo. be cool under pressure. your coolant should perform well under any condition just like aaron rodgers! 2018 hyundai elantra sport 1.6l 4 cyl. turbo. see all videos for the 2018 hyundai elantra. how to flush the coolant antifreeze in a 2018 hyundai elantra sport 1.6l 4 cyl. turbo with petcock, radiator drain flush and burp. Checking your brake fluid from time to time is a great way to ensure safe stopping. 2005 hyundai elantra gls 2.0l 4 cyl. sedan (4 door) replace a burnt out drl. drls are on more than your headlights. they burn out faster and should be replaced regularly. 2005 hyundai elantra gls 2.0l 4 cyl. sedan (4 door). Add antifreeze. low coolant levels is all to common top yours up today. 2019 hyundai elantra se 2.0l 4 cyl. replace reverse light. white light when you back up yup, they burn out and you can replace them with bright leds. 2019 hyundai elantra se 2.0l 4 cyl. replace your wiper blades. Fifth generation (md ud; 2011–2016) hyundai elantra md 2010 2015 service manual engine mechanical system cooling system radiator. repair procedures removal and installation 1.
Hyundai Elantra Coolant Repair Procedures Cooling System Add antifreeze. low coolant levels is all to common top yours up today. 2019 hyundai elantra se 2.0l 4 cyl. replace reverse light. white light when you back up yup, they burn out and you can replace them with bright leds. 2019 hyundai elantra se 2.0l 4 cyl. replace your wiper blades. Fifth generation (md ud; 2011–2016) hyundai elantra md 2010 2015 service manual engine mechanical system cooling system radiator. repair procedures removal and installation 1. Wait until engine is cool, then carefully remove the radiator cap and fill the radiator with engine coolant, then install it on the pressure tester (a). 2. apply a pressure tester to the radiator and apply a pressure of 93.16 ~ 122.58 kpa (0.95 ~ 1.25 kgf cm², 13.51 ~ 17.78 psi). 5. tighten the radiator drain plug securely. 6. after draining engine coolant in the reservoir tank, clean the tank. 7. fill fluid mixture with coolant and water (55~60%) (except for north america, europe and china: 45~50%) slowly through the radiator cap. use only genuine antifreeze coolant.
Hyundai Elantra Coolant Reservoir Tank Cooling System Wait until engine is cool, then carefully remove the radiator cap and fill the radiator with engine coolant, then install it on the pressure tester (a). 2. apply a pressure tester to the radiator and apply a pressure of 93.16 ~ 122.58 kpa (0.95 ~ 1.25 kgf cm², 13.51 ~ 17.78 psi). 5. tighten the radiator drain plug securely. 6. after draining engine coolant in the reservoir tank, clean the tank. 7. fill fluid mixture with coolant and water (55~60%) (except for north america, europe and china: 45~50%) slowly through the radiator cap. use only genuine antifreeze coolant.
Comments are closed.