How To Replace Your Hose And Coolant Basic Motorcycle Maintenance In this episode of basic motorcycle maintenance, our trusted mechanic rob bean shows you exactly what it takes to replace your bikes hoses and coolant, takin. Try a 50 50 mix of vinegar and distilled water instead. run the bike until the radiator fan kicks on, then turn the bike off and let it cool to room temperature. drain the vinegar distilled water mix out, flush the system again with only distilled water, and drain once more.
How To Change Motorcycle Coolant Partzilla Once the system is filled up to the bottom of the radiator neck, leave the cap off, start the bike and let it run for a minute or two, blipping the throttle to help move any remaining air out of the system. if needed, top the radiator and move on to the reservoir tank, which you should fill to the upper line. 8. controls. check your clutch and throttle for smooth operation and adjustment. unstick your clutch and throttle cables with cable lube and this handy tool, and adjust your push and pull cables until you have a tiny bit of slack before the throttle begins to open, and it returns to idle position on its own. Motorcycle coolant change: the basics. put the motorcycle up on a rear stand or side stand and make sure the engine is cold. find and open the radiator filler cap at the top of the cooling system. you may have to disconnect or remove some parts such as the seat, the fuel tank and hoses first on some motorcycles to access the fill cap. Step 2: drain the old coolant. with a container underneath, remove the coolant drain bolt and washer from the bottom of the water pump on the left hand side. this bike takes 2.3 litres of coolant, so make sure your container is large enough. if your bike has any bleed bolts, keep them loose until you fill the system back up.
How To Change Motorcycle Coolant Expert Advice The Moto Planet Motorcycle coolant change: the basics. put the motorcycle up on a rear stand or side stand and make sure the engine is cold. find and open the radiator filler cap at the top of the cooling system. you may have to disconnect or remove some parts such as the seat, the fuel tank and hoses first on some motorcycles to access the fill cap. Step 2: drain the old coolant. with a container underneath, remove the coolant drain bolt and washer from the bottom of the water pump on the left hand side. this bike takes 2.3 litres of coolant, so make sure your container is large enough. if your bike has any bleed bolts, keep them loose until you fill the system back up. As a general rule, your motorcycle’s coolant should be changed every two years or every 24,000 miles, even if it looks good. cloudy or brownish coolant should always be drained and replaced. check your owner’s manual for the specific coolant change interval for your bike. you might also need to change your motorcycle’s coolant for a track. Keeping some engine oil and brake fluid in your workspace for topping up is a good idea. you should also include chain lube, brake cleaner, degreaser, penetrating oil, such as 3in1, wd40, hand cleanser and bike cleaner. nitrile gloves are also a smart move when carrying out any motorcycle maintenance.
Comments are closed.