How To Replace Upper Radiator Fan Shroud 1999 2006 Chevrolet Silverado Buy now!new radiator fan shroud from 1aauto 1aau.to ib 1arfs00014this video shows you how to install a new upper radiator fan shroud from trq on y. How to remove the radiator fan shroud. part of the series: how to replace a radiator. removing your radiator fan shroud away from the radiator is done by rem.
Chevrolet Silverado 1999 2006 Gmt800 How To Replace Upper Radiator Hose Step 1 – drain the coolant. allow the engine to cool down before working on components under the hood. pop the hood of your truck, and remove the cap on the coolant overflow tank. underneath the driver's side, bottom corner of the radiator is its drain plug (thumb screw). position an oil drip pan directly underneath the drain port. Remove the hose from the clamp. remove the two 10mm screws at the top of the fan shroud. pop out the trim buttons from the shroud. lift the shroud up and out. step 3 :installing the upper radiator fan shroud. 2:53. insert the shroud into place. press on the trim buttons. tighten the two 10mm screws to the shroud. Step 3 – remove the radiator fan. attach a large adjustable wrench to the nut holding the fan to the water pump pulley. rotate the nut counterclockwise to loosen and remove the fan. if the fan is on too tight, you can use a hammer to knock the wrench and force the nut loose. remove the fan by rotating the blades counterclockwise until the fan. But that is a v 8 the fan shroud is much shorter front to back on the v 8's as compared to the v 6 4.3 engine. apparently the v 6 engine sits on the same motor mounts as the v 8 engine and the radiator is in the same place so to make the fan work well gm extends the shroud to make up the difference in engine lengths. <g>.
How To Replace Radiator Cooling Fan Assembly 07 13 Chevy Silverado 1500 Step 3 – remove the radiator fan. attach a large adjustable wrench to the nut holding the fan to the water pump pulley. rotate the nut counterclockwise to loosen and remove the fan. if the fan is on too tight, you can use a hammer to knock the wrench and force the nut loose. remove the fan by rotating the blades counterclockwise until the fan. But that is a v 8 the fan shroud is much shorter front to back on the v 8's as compared to the v 6 4.3 engine. apparently the v 6 engine sits on the same motor mounts as the v 8 engine and the radiator is in the same place so to make the fan work well gm extends the shroud to make up the difference in engine lengths. <g>. Step 1 :removing the radiator fan assembly. 0:21. disconnect the two electrical connectors from the fans. unclip the wiring harness from the fan shroud. remove the two 13mm bolts from the top of the fan shroud. lift the fan assembly off the clips and out of the engine bay. Add to cart. make sure this part fits, select vehicle. product specifications. other name: shroud, radiator fan shroud; fan shroud, upper shroud. position: upper. replaces: 15860926. warranty: this genuine part is guaranteed by gm's factory warranty. fits the following vehicles: 2006 2010 chevrolet silverado | 2500 crew cab long box, 2500 crew.
Comments are closed.