How To Replace The Car A C Evaporator Kia Hyundai Toyota @kia, @hyundai, @toyota, @nissan @mitsubishi. This is the easy way to replace evaporator of hyundai. all model of hyundai and kia you can replace evaporator with this way.hyundai accent, i10,elentra,tucs.
How To Replace An Ac Evaporator Sensor Yourmechanic Advice We are continuing our series on how to diagnose and repair your vehicle's a c system. the last two episodes dealt with low refrigerant (low r 134a refrigeran. 5. apply the cleaner. after removing any junk in the air conditioner assembly, it is time to clean the evaporator coil. this can get messy, so putting some plastic on the car’s floor is a good idea. next, i get out my coil cleaner and apply it to the evaporator coil. there are a few different kinds of coil cleaners. Some tips: (1) make sure you have the adapter to dispense the cleaner into the prip tube under the car. (2) make sure the adapter is securely placed and leave it there for the 10 min. time to clean and then do a second dose. (3) while waiting for the 20 minutes plus the 10 to drain, remove the glove box in a kia soul which is 8 screws and a. Step 10: reinstall the evap temperature sensor. screw the new sensor into the ac condenser, turning it to the right. step 11: reinstall the support clip. in some cases, you'll have to reinstall the support clip on top of the sensor. if this is the case, simply press the clip onto the back of the sensor.
How To Replace Car Aircon Evaporator Eon Youtube Some tips: (1) make sure you have the adapter to dispense the cleaner into the prip tube under the car. (2) make sure the adapter is securely placed and leave it there for the 10 min. time to clean and then do a second dose. (3) while waiting for the 20 minutes plus the 10 to drain, remove the glove box in a kia soul which is 8 screws and a. Step 10: reinstall the evap temperature sensor. screw the new sensor into the ac condenser, turning it to the right. step 11: reinstall the support clip. in some cases, you'll have to reinstall the support clip on top of the sensor. if this is the case, simply press the clip onto the back of the sensor. Secure the vacuum pump and empty tank to the manifold. turn on the vacuum pump to completely vacuum the system. open the low and high side valves on the manifold and let the system vacuum check (this should be done for a minimum of 30 minutes). close low and high valves on the manifold and turn vacuum pump off. The ac evaporator is part of a car's air conditioning system. it's a coil like component behind the dashboard that uses a refrigerant liquid to stay very cold. then, the ac draws the warm air inside the cabin and throws it on this coil. next, the air becomes cold through the coil and is blown back inside the cabin.
Comments are closed.