How To Replace A Pvc Sink Trap This Old House Steps: 1 remove the drain plug from the bottom of the sink trap with pliers; use a foil baking pan to catch the water that drains out. 2 use a reciprocating saw to cut out the existing pvc sink trap. 3 loosen the compression fitting that connects the trap to the sink drain; remove the entire pvc assembly. 4 use a special pvc cutterhead in a. This old house plumbing and heating expert richard trethewey shows how to replace a leaky, glued together kitchen sink trap. (see below for a shopping list a.
How To Replace A Pvc Sink Trap This Old House Youtube This old house plumbing and heating expert richard trethewey re plumbs a poorly draining sink. (see below for a shopping list and tools.)subscribe to this ol. Step 2: prepare the drainpipes. use pvc primer and cement to glue a solid plug over the end of one drainpipe stub out. glue a threaded cleanout plug onto the end of another stub out. locate the dishwasher connection on the side of the garbage disposer. remove the knockout plug from the disposer using a screwdriver. Follow these steps: dry assemble the abs drainpipe and trap to ensure an appropriate fit. cut the pipe to the correct length using a plastic pipe cutter. glue the drainpipes to each trap using abs cement. install a mini vent valve to the drainpipe to prevent air locks. Connect a trap bend to the trap arm. attach the trap bend to the trap arm, using slip nuts and washers. the beveled side of the washers should face the trap bend. tighten all the nuts with a pair of slip joint pliers. never use teflon tape on white plastic pipe threads and fittings.
A Great 6 Step Guide To Replace Sink Trap For Homeowners Balkan Drain Follow these steps: dry assemble the abs drainpipe and trap to ensure an appropriate fit. cut the pipe to the correct length using a plastic pipe cutter. glue the drainpipes to each trap using abs cement. install a mini vent valve to the drainpipe to prevent air locks. Connect a trap bend to the trap arm. attach the trap bend to the trap arm, using slip nuts and washers. the beveled side of the washers should face the trap bend. tighten all the nuts with a pair of slip joint pliers. never use teflon tape on white plastic pipe threads and fittings. Assemble the parts. slide the trap arm into the drain opening in the wall. fit the trap bend over the end of the trap arm and onto the sink tailpiece. (if a tailpiece extension is used, position it at this time.) slide the slip nuts against the fittings, and loosely thread them onto the threaded hubs. Combine the tailpieces, then build from the bottom up. connect the tailpieces. use a 90° bend and a sanitary tee with slip nut connections to draw the drain water into one tailpiece. the connection arm should slope down by 1 4 in. per ft. if needed, provide a stub for the dishwasher drain in the tailpiece. measure to connect the cleanout.
Comments are closed.