How To Properly Adjust Headlights At Erica Kellogg Blog Step 3: level the car. push down all four corners of the vehicle up and down a few times to settle the suspension and make sure the shocks are level. step 4: measure the lights. use the tape measure to measure from a fixed point on each of the headlamps down to the ground. Step 4: measure the lights. use the tape measure to measure from a fixed point on each of the headlamps down to the ground. the measurements should be within a half inch of each other. this will verify the suspension is not sagging on either side, which would throw off the measurements. step 5: turn on the headlights.
How To Properly Adjust Headlights At Erica Kellogg Blog Adjusting the lights. 1. find the adjustment screws. 2. adjust the headlights individually. 3. adjust the vertical field – the screw at the top of the headlight is for vertical adjustments. 4. adjust the horizontal field – the screw on the side of the headlight is for horizontal adjustments. Pop the hood and look for adjustment screws on top of each bulb. adjust these screws as needed until your headlights are correct. the lights are correct when the area below the horizontal line is illuminated and the bright spots are centered on the middle of each . method 1. Measure the distance from the ground up to the height of the center of your headlights. transfer these measurements to the wall and mark them on the tape. do that for both sides. measure down two inches from the center marks and draw a horizontal line across the tape. this will create a cross section for each headlight. Next, find a plain wall. pull the car as close to the wall as possible and turn on your lights. this way, you’ll find the centers of the low beam headlights. mark both spots with a single piece.
How To Properly Adjust Headlights At Erica Kellogg Blog Measure the distance from the ground up to the height of the center of your headlights. transfer these measurements to the wall and mark them on the tape. do that for both sides. measure down two inches from the center marks and draw a horizontal line across the tape. this will create a cross section for each headlight. Next, find a plain wall. pull the car as close to the wall as possible and turn on your lights. this way, you’ll find the centers of the low beam headlights. mark both spots with a single piece. Step 3. turn headlights on and mark the center of each headlight beam with a cross of masking or painter’s tape. use a bubble level to ensure that the tape is level with the ground. for added precision, you can also measure vertically from the ground to each headlight to get its height and apply a corresponding mark on the wall. To adjust the headlights, have your helper sit in the driver’s seat. next, raise the hood and locate the adjustment mechanisms. usually, there are two screws close to each light fixture, one for vertical adjustment and one for horizontal adjustment. to adjust one, block the light from the other using a towel or coat.
Comments are closed.