How To Flush The Radiator On Your Motorcycle And Change The Coolant Try a 50 50 mix of vinegar and distilled water instead. run the bike until the radiator fan kicks on, then turn the bike off and let it cool to room temperature. drain the vinegar distilled water mix out, flush the system again with only distilled water, and drain once more. Watch our detailed how to video. loosen the radiator cap but do not fully remove it. place a bowl under the drain bolt to collect coolant. remove drain bolt from the water pump. empty radiator fully of coolant. flush system with a 50 50 mixture of distilled water with vinegar. refit drain bolt.
How To Flush Your Motorcycle Radiator How to change the coolant and flush the radiator on your motorcycle. complete guide!00:00 getting started01:00 warning01:22 draining the coolant03:38 poison. Position a drain pan under the bike and unscrew the drain bolt. the fluid will dribble out slowly until you crack the radiator cap, and then it’ll come pouring out. if the reservoir tank has a. We go into detail explaining the differences in ethylene glycol vs propylene glycol, why many race tracks don't allow glycol, then walk you through, step by. Summer heat isn’t just hard on you as a rider; it’s also hard on your engine. make it a little easier by performing a cooling system service. most owner’s ma.
How To Flush Your Motorcycle Coolant Change Motorcycle Radiator We go into detail explaining the differences in ethylene glycol vs propylene glycol, why many race tracks don't allow glycol, then walk you through, step by. Summer heat isn’t just hard on you as a rider; it’s also hard on your engine. make it a little easier by performing a cooling system service. most owner’s ma. Step 2: drain the old coolant. with a container underneath, remove the coolant drain bolt and washer from the bottom of the water pump on the left hand side. this bike takes 2.3 litres of coolant, so make sure your container is large enough. if your bike has any bleed bolts, keep them loose until you fill the system back up. Once the system is filled up to the bottom of the radiator neck, leave the cap off, start the bike and let it run for a minute or two, blipping the throttle to help move any remaining air out of the system. if needed, top the radiator and move on to the reservoir tank, which you should fill to the upper line.
How To Flush Motorcycle Radiator Detailed Video Guide Step 2: drain the old coolant. with a container underneath, remove the coolant drain bolt and washer from the bottom of the water pump on the left hand side. this bike takes 2.3 litres of coolant, so make sure your container is large enough. if your bike has any bleed bolts, keep them loose until you fill the system back up. Once the system is filled up to the bottom of the radiator neck, leave the cap off, start the bike and let it run for a minute or two, blipping the throttle to help move any remaining air out of the system. if needed, top the radiator and move on to the reservoir tank, which you should fill to the upper line.
How To Change Motorcycle Coolant Radiator Flush Complete Guide
Comments are closed.