How To Flush The Radiator On Your Motorcycle And Change The Coolant Motorcycle coolant flush and radiator flush. if you want to flush your system of rust or scale before adding the new coolant, it’s probably best to avoid harsh chemical products. try a 50 50 mix of vinegar and distilled water instead. run the bike until the radiator fan kicks on, then turn the bike off and let it cool to room temperature. How to change the coolant and flush the radiator on your motorcycle. complete guide!00:00 getting started01:00 warning01:22 draining the coolant03:38 poison.
How To Flush Your Motorcycle Coolant Change Motorcycle Radiator Watch our detailed how to video. loosen the radiator cap but do not fully remove it. place a bowl under the drain bolt to collect coolant. remove drain bolt from the water pump. empty radiator fully of coolant. flush system with a 50 50 mixture of distilled water with vinegar. refit drain bolt. Summer heat isn’t just hard on you as a rider; it’s also hard on your engine. make it a little easier by performing a cooling system service. most owner’s ma. We go into detail explaining the differences in ethylene glycol vs propylene glycol, why many race tracks don't allow glycol, then walk you through, step by. Position a drain pan under the bike and unscrew the drain bolt. the fluid will dribble out slowly until you crack the radiator cap, and then it’ll come pouring out. if the reservoir tank has a.
How To Flush And Change Your Motorcycle Coolant Bikersrights We go into detail explaining the differences in ethylene glycol vs propylene glycol, why many race tracks don't allow glycol, then walk you through, step by. Position a drain pan under the bike and unscrew the drain bolt. the fluid will dribble out slowly until you crack the radiator cap, and then it’ll come pouring out. if the reservoir tank has a. Step 2: drain the old coolant. with a container underneath, remove the coolant drain bolt and washer from the bottom of the water pump on the left hand side. this bike takes 2.3 litres of coolant, so make sure your container is large enough. if your bike has any bleed bolts, keep them loose until you fill the system back up. Motorcycle coolant change: the basics. put the motorcycle up on a rear stand or side stand and make sure the engine is cold. find and open the radiator filler cap at the top of the cooling system. you may have to disconnect or remove some parts such as the seat, the fuel tank and hoses first on some motorcycles to access the fill cap.
Comments are closed.