How To Drain Fill And Bleed Coolant System 00 06 Chevy Suburban Youtube For more info visit us at: 1aau.to h ug in this video, 1a auto shows you how to check and refill the engine coolant level on the 02 chevy suburbanthis. Twist off the coolant bottle cap. have a drain pan ready. twist off the radiator drain plug. allow the coolant to drain. twist on the radiator drain plug. step 2 :filling the coolant. 1:41. add coolant to the coolant bottle using a funnel. twist on the coolant bottle cap.
How To Drain Fill Bleed Radiator 07 14 Chevy Suburban Youtube In this video we show how to drain and fill the coolant 2000 2006 chevrolet tahoe. 2carpros articles coolant flush and refill all carsif you ha. In this video, jake diy’s how to drain, bleed, and change the coolant in our 2002 5.3 vortec chevrolet suburban 1500. this coolant flush and refill diy appli. Have a drain pan ready. twist off the radiator drain plug. allow the coolant to drain. twist on the drain plug. step 2 :filling the coolant. 1:06. add coolant to the coolant bottle with a funnel. twist on the coolant bottle cap. run the engine briefly. Start the truck and use warm water to flush out the rest. you will see orange come out of the radiator, when it is clear you have all the dex cool out. make sure the engine is at operating temp and the thermostat has opened. then, reconnect everything and fill w. a 50 50 mix. to bleed, open the fill cap next to the washer fluid.
Diy How To Drain Bleed And Change Your Coolant 00 06 Chevrolet Have a drain pan ready. twist off the radiator drain plug. allow the coolant to drain. twist on the drain plug. step 2 :filling the coolant. 1:06. add coolant to the coolant bottle with a funnel. twist on the coolant bottle cap. run the engine briefly. Start the truck and use warm water to flush out the rest. you will see orange come out of the radiator, when it is clear you have all the dex cool out. make sure the engine is at operating temp and the thermostat has opened. then, reconnect everything and fill w. a 50 50 mix. to bleed, open the fill cap next to the washer fluid. Remove the 7mm bolts from the fender liner. pry out the barbed clips in the liner with a flat blade screwdriver. peel back the fender liner. step 2 :draining the radiator. 1:53. have a drain bucket ready. loosen the hose clamp on the lower radiator hose. pry off the lower radiator hose. let the coolant drain. Fill the coolant surge tank to the following levels:. at or above the min mark on the pickup to the cold fill mark on the van. 5. replace the pressure cap. be sure the pressure cap is hand tight and fully seated. 6. verify coolant level after the engine is shut off and the coolant is cold. if necessary, repeat coolant fill procedure steps 1 6.
Comments are closed.