How To Drain Fill And Bleed Coolant Cooling System 09 17 Chevy For more info visit us at: 1aau.to h w in the video, 1a auto shows how to drain, flush, and refill your coolant. the video is applicable to the 09, 10. 0:22. make sure the engine is cool. open the hood. have a drain pan ready. loosen the lower radiator hose clamp with slip joint pliers. pull the hose off the engine. direct the fluid into the drain bucket. allow the coolant to drain completely. step 2 :removing the engine compartment shield.
How To Bleed Your Car S Cooling System Axleaddict Fill up the radiator with distilled water and run the engine. turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50 50 coolant distilled water mixture and burp the system. like the oil in your traverse, coolant gets dirty over time and loses its ability to cool down your 3.6 liter engine. Start the truck and use warm water to flush out the rest. you will see orange come out of the radiator, when it is clear you have all the dex cool out. make sure the engine is at operating temp and the thermostat has opened. then, reconnect everything and fill w. a 50 50 mix. to bleed, open the fill cap next to the washer fluid. Fill the coolant surge tank to the following levels:. at or above the min mark on the pickup to the cold fill mark on the van. 5. replace the pressure cap. be sure the pressure cap is hand tight and fully seated. 6. verify coolant level after the engine is shut off and the coolant is cold. if necessary, repeat coolant fill procedure steps 1 6. This is how i change the coolant.
How To Drain And Flush Radiator Coolant In Under 30 Minutes Fill the coolant surge tank to the following levels:. at or above the min mark on the pickup to the cold fill mark on the van. 5. replace the pressure cap. be sure the pressure cap is hand tight and fully seated. 6. verify coolant level after the engine is shut off and the coolant is cold. if necessary, repeat coolant fill procedure steps 1 6. This is how i change the coolant. Step 6: rev the engine to 3000 4000 rpm. put your friend into the car and let him rev up your engine to around 3000 4000 rpm. this could cause the coolant to flow out of the radiator if you do not use the spill tool. keep the rpms steady while you are working in the system. make sure that the coolant is not getting too hot while you work on it. Fill up the radiator with distilled water and run the engine. turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50 50 coolant distilled water mixture and burp the system. like the oil in your traverse, coolant gets dirty over time and loses its ability to cool down your 3.6 liter engine.
How To Bleed Air From Your Cooling System Doityourself Step 6: rev the engine to 3000 4000 rpm. put your friend into the car and let him rev up your engine to around 3000 4000 rpm. this could cause the coolant to flow out of the radiator if you do not use the spill tool. keep the rpms steady while you are working in the system. make sure that the coolant is not getting too hot while you work on it. Fill up the radiator with distilled water and run the engine. turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50 50 coolant distilled water mixture and burp the system. like the oil in your traverse, coolant gets dirty over time and loses its ability to cool down your 3.6 liter engine.
How To Drain And Flush A Radiator And Cooling System
Comments are closed.