How An Evaporative Cooler Works And How To Winterize Them Youtube America's #1 choice for quality, affordable hvac equipment: alpinehomeair all my favorite hvac tools: amazon shop thediyhvacg. Step 1: cooling media pads. dry the evaporative cooler unit completely, including the pads. then remove the media pads. replace the cooling media pads. since pads only last one season, they’ll need to be replaced for the next season. we suggest replacing the pads now so you have one less step when you pull it back out.
How To Winterize Your Evaporative Cooler Youtube Evaporative coolers are made up of four essential parts: a fan, a water tank, filter pads (sometimes called media) and an internal motor. the motor pulls warm air through a wet internal filter pad, where the evaporation process quickly lowers its temperature before it is circulated back into the room. the internal pads also act as a filter. Connect any water supply lines, if applicable, or electrical cords. install the filter and the honeycomb cooling pads. fill the unit with water or turn on the water supply if your unit connects to a hose. position the unit in front of an open window or door. make sure there’s adequate cross ventilation. Change the cooler pads in the fall when winterizing the unit. most people think of doing this in the spring when starting the cooler up. keep in mind, the old pads have had minerals building up in them all through the summer. the way the louver panels are originally built, they cause any rainwater to flow into the cooler and run down the pads. We're often asked about #swampcoolerwinterization. it's important to shut it down correctly! check out our video to walk you through all the steps. as always.
Evaporative Cooler Stingray Change the cooler pads in the fall when winterizing the unit. most people think of doing this in the spring when starting the cooler up. keep in mind, the old pads have had minerals building up in them all through the summer. the way the louver panels are originally built, they cause any rainwater to flow into the cooler and run down the pads. We're often asked about #swampcoolerwinterization. it's important to shut it down correctly! check out our video to walk you through all the steps. as always. Turn it off, unplug it and disconnect the motor and pump. then, fully drain the water supply. wipe off the exterior, water reservoir and filters with a damp cloth and let everything air dry. wrap the cord and cover the unit with an evaporative cooler cover. store the cooler in a covered space that is cool and dry. Clean the cooler. next, use a non toxic cleaner or soapy water and sponge to clean out the pan of the cooler. make sure to rinse thoroughly and let stand to dry completely before taking the next steps. put a fan in the room that will blow directly on the pan to speed up the process.
Comments are closed.