How To Drain Fill And Bleed Coolant System 00 06 Chevy Suburban Youtube In this video we show how to drain and fill the coolant 2000 2006 chevrolet tahoe. 2carpros articles coolant flush and refill all carsif you ha. For more info visit us at: 1aau.to h ug in this video, 1a auto shows you how to check and refill the engine coolant level on the 02 chevy suburbanthis.
Coolant Drain Fill 2000 2006 Chevrolet Tahoe Suburban Youtube In this video, jake diy’s how to drain, bleed, and change the coolant in our 2002 5.3 vortec chevrolet suburban 1500. this coolant flush and refill diy appli. Twist off the coolant bottle cap. have a drain pan ready. twist off the radiator drain plug. allow the coolant to drain. twist on the radiator drain plug. step 2 :filling the coolant. 1:41. add coolant to the coolant bottle using a funnel. twist on the coolant bottle cap. Step 1 :draining the coolant. 0:26. twist of the coolant bottle cap. have a drain pan ready. twist off the radiator drain plug. allow the coolant to drain. twist on the drain plug. step 2 :filling the coolant. 1:06. 2003 chevrolet suburban 1500 lt 5.3l v8. add air to your tires. properly inflated tires is the easiest way to improve fuel economy. the right tire pressure is not on the side of your tire btw. 2000 chevrolet silverado 1500 4.3l v6 standard cab pickup (2 door) see all videos for the 2003 chevrolet suburban 1500.
How To Replace Coolant Reservoir 2000 2006 Chevrolet Tahoe 1a Auto Step 1 :draining the coolant. 0:26. twist of the coolant bottle cap. have a drain pan ready. twist off the radiator drain plug. allow the coolant to drain. twist on the drain plug. step 2 :filling the coolant. 1:06. 2003 chevrolet suburban 1500 lt 5.3l v8. add air to your tires. properly inflated tires is the easiest way to improve fuel economy. the right tire pressure is not on the side of your tire btw. 2000 chevrolet silverado 1500 4.3l v6 standard cab pickup (2 door) see all videos for the 2003 chevrolet suburban 1500. 1. follow the steps below in order to remove the surge tank fill cap. 2. raise and support the vehicle. refer to lifting and jacking the vehicle . 3. place a drain pan under the lower radiator hose. 4. using the j 38185 , reposition the lower radiator hose clamp. 5. remove the lower radiator hose from the radiator. 6. drain the cooling system. 7. If you going to do it yourself then park with the rear end up at slight angle or maybe use a jack to lift the rear end just a little, remove the lower radiator hose and the reservoir cap, let it drain, after it has drained you can squeeze the hoses a little or even crank the motor a couple turns. put the hose back on fill with just water, (optionally you could also add some citric acid.
Comments are closed.