Blend Door Actuator Removal Instructions Needed Any Techs Share A 2011 chevrolet malibu. 2.2l. 4 cyl. 2wd. automatic. 90,000 miles. any techs share a repair manual alldata pdf on part explosion and or getting the entire dash off. i believe i have a failing blend door. wednesday, december 16th, 2020 at 3:51 pm. The instructions are written with short instructions for the experienced technician in normal type and further explanation for the novice installer in italics. 1. disconnect the negative terminal of the battery. 2. remove the blend door actuator motor. tools required: screw driver socket wrench set rotary cutting tool (preferably with.
Blend Door Actuator Removal And Installation The blend door has an electric actuator that helps control its position. most blend door actuators have a built in feedback sensor that keeps the climate control apprised of the door’s position. the most common symptoms of a bad blend door actuator include abnormal noises, incorrect climate control outlet temperature, and varying outlet. Set the temperature knob all the way into the cold position. the mode knob must be in defrost. the a c button can be on or off. press and hold the ebl button until ac00 appears in the odometer display. you will hear a chime and the a c light will blink. release the ebl button and wait for the a c light to stop blinking. Remove the glove box. locate the recirculation blend door assembly on the right side of the dash. it is located behind the hvac control panel. disconnect the electrical connector from the actuator. use the 7mm socket and ratchet to remove the two screws that secure the actuator to the housing. First things first, open the hood the disconnect the negative battery cable. pry the air vents off of the dashboard. lift the side and remove the dashboard panels. remove the two phillips screws located under the dashboard side panels. remove the screws from behind the air vents. figure 1. remove the side panels.
Blend Door Actuator Removal And Installation Remove the glove box. locate the recirculation blend door assembly on the right side of the dash. it is located behind the hvac control panel. disconnect the electrical connector from the actuator. use the 7mm socket and ratchet to remove the two screws that secure the actuator to the housing. First things first, open the hood the disconnect the negative battery cable. pry the air vents off of the dashboard. lift the side and remove the dashboard panels. remove the two phillips screws located under the dashboard side panels. remove the screws from behind the air vents. figure 1. remove the side panels. For manual climate control, there is only 1 blend door actuator (lh): temperature blend door actuator — lh. 2010 fusion temperature blend door actuator — lh item part number description. 1 — lh temperature blend door actuator electrical connector (part of 19d887) 2 w712320 lh temperature blend door actuator screw (2 required) 3 19e616. 5. remove the blend door through the hole that you cut in the box. 6. insert the replacement door into position in the box. 7. slide the motor axle into the blend door connection and loose fit the motor to the box. 8. replace the cut out into the hole and secure it in place with the two bottom screws and seal the cuts 9. replace the heater.
How To Replace The Blend Door Actuator For manual climate control, there is only 1 blend door actuator (lh): temperature blend door actuator — lh. 2010 fusion temperature blend door actuator — lh item part number description. 1 — lh temperature blend door actuator electrical connector (part of 19d887) 2 w712320 lh temperature blend door actuator screw (2 required) 3 19e616. 5. remove the blend door through the hole that you cut in the box. 6. insert the replacement door into position in the box. 7. slide the motor axle into the blend door connection and loose fit the motor to the box. 8. replace the cut out into the hole and secure it in place with the two bottom screws and seal the cuts 9. replace the heater.
Comments are closed.