Api 6d Valve Testing Procedure Pressure Duration The test pressure for all seat tests shall be a minimum of 1.1 times the pressure rating conforming to 4.3 for material at 100 °f (38 °c) based on the valve end connector material. the test duration shall conform to table 10 based on the valve end connector size. table 10—minimum duration of hydrostatic seat tests. Scope: api 6d trunnion mounted ball valves. 2. process. the test bed must allow all the required pressures to be reached (1.5 x pn) and incorporate all the necessary accessories for the correct running of the tests: vents, water and air connections, manometers, receptacles with the necessary quantity of water, etc.
Api 6d Hydro Static Valve Testing Procedure How To Test An Api 6d A. 150% of the max pressure rating. b. 150% of the max pressure rating. c. 150% of the max pressure rating. shell hydrostatic test is carried out with half opened valve. hydraulic. 5 min. a. atmospheric. b. atmospheric. c. 110% of the max pressure rating. There are three types of tests required under api 6d: stem backseat test. hydrostatic shell test. hydrostatic seat test. for valves up to 16” x 300 lbs, we can perform these tests using our barbee tf 100 daq test stand. we have tested up to 24” 900# in the shop, and we can test larger valves with bolt on flanges into the valve. 2 tests each seat required. reduce pressure to zero and cycle valve fully open and fully closed and repeat test of each seat. 3 tests each seat are required. reduce pressure to zero and cycle fully open and fully closed after each test. test 1 and 3 shall have test duration as specified in table 11. 7 3. low pressure valve seat test (gas) with the valve closed fully, test in both directions, one direction at a time at pressure of 0.6mpag. use leak detector spray on entire seal area to ensure zero leakage. the test duration shall be as shown in table 3. 7 4. acceptance criteria of closure test (iso5208) 7 5. after pressure testing.
Pressure Testing Of Valves Api 6d Iso14313 2 tests each seat required. reduce pressure to zero and cycle valve fully open and fully closed and repeat test of each seat. 3 tests each seat are required. reduce pressure to zero and cycle fully open and fully closed after each test. test 1 and 3 shall have test duration as specified in table 11. 7 3. low pressure valve seat test (gas) with the valve closed fully, test in both directions, one direction at a time at pressure of 0.6mpag. use leak detector spray on entire seal area to ensure zero leakage. the test duration shall be as shown in table 3. 7 4. acceptance criteria of closure test (iso5208) 7 5. after pressure testing. Our api 6d certified valves represent the state of the art for ball valve technology. the valves are double block and bleed, ansi 150, ansi 300, and ansi 600. scope this technical manual applies to broen inc. api 6d certified valves manufactured after november 2022. valves manufactured after this date are made to comply with the 25th edition of. H.4.2 high pressure gas shell testing h.4.2.1 general valves shall have a high pressure gas shell test performed using inert gas as the test medium. test shall be performed using 99 % nitrogen with a 1 % helium tracer measured using a mass spectrometer. the minimum test pressure shall be 1.1 times the pressure rating determined in accordance.
Comments are closed.